BGP

Hi Expert,
          Im doing BGP lab I create BGP neigh relationship between R1 and
SW1 but its not coming I also run eigrp because it is not
directly neigh so from eigrp I'm getting route of SW1 and I'm also able to
ping but in bgp sh ip bgp summ command R1 status with Sw1 is active .means
there is no bgp neigh relation.
Actually from R1 there is two path to reach Sw1

SW1 - R6- R1-connected with R3 and R3 - Sw1 mean there is ring topology

 R1 getting routes from Sw1 via R3 and I create and my bgp neigh from R1 -
R6 - sw1

So my Q is that is bgp neigh relation is also depend on IGP
path selection.Because when I create static to words Sw1 by using same path
where I configure my BGP neigh relation its work R1 - R6 - Sw1 its work
fine.
But removing static neigh state becomes again active because eigrp getting
sw1 routes via R3 .. R1 - R3 -Sw1

Thanks.

Blogs and organic groups at http://www.ccie.net
Received on Wed May 06 2009 - 16:56:01 ART