L3 etherchannel Dynamips

Hi Guys

Any help on the issue below I am experiencing any ideas

Rack1SW2(config)#int po2
Rack1SW2(config-if)#ip address 155.1.108.8 255.255.255.0

% IP addresses may not be configured on L2 links.

Rack1SW2(config-if)#no switchport
Command rejected: not allowed under port channel.
Rack1SW2(config-if)#

Rack1SW2(config-if)#do show run int port 2
Building configuration...

Current configuration : 31 bytes
!
interface Port-channel2
end

Rack1SW2(config-if)#do show run int fa 1/13
Building configuration...

Current configuration : 59 bytes
!
interface FastEthernet1/13
 channel-group 2 mode on
end

Rack1SW2(config-if)#do show run int fa 1/14
Building configuration...

Current configuration : 59 bytes
!
interface FastEthernet1/14
 channel-group 2 mode on
end

Rack1SW2(config-if)#do show run int fa 1/15
Building configuration...

Current configuration : 59 bytes
!
interface FastEthernet1/15
 channel-group 2 mode on
end

Rack1SW2(config-if)#do show int port 2
Port-channel2 is up, line protocol is up
  Hardware is EtherChannel, address is c20a.0da8.f10f (bia c20a.0da8.f10f)
  MTU 1500 bytes, BW 300000 Kbit/sec, DLY 1000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed
  Members in this channel: Fa1/13 Fa1/14 Fa1/15
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:01, output never, output hang never
  Last clearing of "show interface" counters never
  Input queue: 39/75/370/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 input packets with dribble condition detected
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out
Rack1SW2(config-if)#do show version
Cisco IOS Software, 3700 Software (C3725-ADVENTERPRISEK9-M), Version
12.4(15)T10, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Mon 14-Sep-09 15:53 by prod_rel_team

Blogs and organic groups at http://www.ccie.net
Received on Fri Feb 19 2010 - 12:14:06 ART