Re: L3 etherchannel Dynamips

Doesnt work tried it

On 19 February 2010 18:54, Bobola Oke <okebobola_at_gmail.com> wrote:

> hey edmore,
> use no switchport command on the individual interfaces first before
> bundling them up
> it should work, i think
>
> but i dont think you're having dynamips problem
>
>
> On Fri, Feb 19, 2010 at 12:37 PM, Tolulope Ogunsina <togunsina_at_gmail.com>wrote:
>
>> Hi,
>> Dynamips does NOT emulate switches or ISRs.
>> The NM16ESW module is still NOT a switch :-)
>>
>> Configuration features of the Etherswitch module are documented here:
>>
>>
>> http://www.cisco.com/en/US/docs/ios/lanswitch/configuration/guide/lsw_enet_switch_net_ps6350_TSD_Products_Configuration_Guide_Chapter.html
>>
>>
>> The NM16ESW does not support layer 3 etherchannels.
>>
>> On 2/19/10, Edmore Chingwena <chingwenaed_at_gmail.com> wrote:
>> > Hi Guys
>> >
>> > Any help on the issue below I am experiencing any ideas
>> >
>> > Rack1SW2(config)#int po2
>> > Rack1SW2(config-if)#ip address 155.1.108.8 255.255.255.0
>> >
>> > % IP addresses may not be configured on L2 links.
>> >
>> > Rack1SW2(config-if)#no switchport
>> > Command rejected: not allowed under port channel.
>> > Rack1SW2(config-if)#
>> >
>> > Rack1SW2(config-if)#do show run int port 2
>> > Building configuration...
>> >
>> > Current configuration : 31 bytes
>> > !
>> > interface Port-channel2
>> > end
>> >
>> > Rack1SW2(config-if)#do show run int fa 1/13
>> > Building configuration...
>> >
>> > Current configuration : 59 bytes
>> > !
>> > interface FastEthernet1/13
>> > channel-group 2 mode on
>> > end
>> >
>> > Rack1SW2(config-if)#do show run int fa 1/14
>> > Building configuration...
>> >
>> > Current configuration : 59 bytes
>> > !
>> > interface FastEthernet1/14
>> > channel-group 2 mode on
>> > end
>> >
>> > Rack1SW2(config-if)#do show run int fa 1/15
>> > Building configuration...
>> >
>> > Current configuration : 59 bytes
>> > !
>> > interface FastEthernet1/15
>> > channel-group 2 mode on
>> > end
>> >
>> > Rack1SW2(config-if)#do show int port 2
>> > Port-channel2 is up, line protocol is up
>> > Hardware is EtherChannel, address is c20a.0da8.f10f (bia
>> c20a.0da8.f10f)
>> > MTU 1500 bytes, BW 300000 Kbit/sec, DLY 1000 usec,
>> > reliability 255/255, txload 1/255, rxload 1/255
>> > Encapsulation ARPA, loopback not set
>> > Keepalive set (10 sec)
>> > Auto-duplex, Auto-speed
>> > Members in this channel: Fa1/13 Fa1/14 Fa1/15
>> > ARP type: ARPA, ARP Timeout 04:00:00
>> > Last input 00:00:01, output never, output hang never
>> > Last clearing of "show interface" counters never
>> > Input queue: 39/75/370/0 (size/max/drops/flushes); Total output drops:
>> 0
>> > Queueing strategy: fifo
>> > Output queue: 0/40 (size/max)
>> > 5 minute input rate 0 bits/sec, 0 packets/sec
>> > 5 minute output rate 0 bits/sec, 0 packets/sec
>> > 0 packets input, 0 bytes, 0 no buffer
>> > Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
>> > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
>> > 0 input packets with dribble condition detected
>> > 0 packets output, 0 bytes, 0 underruns
>> > 0 output errors, 0 collisions, 1 interface resets
>> > 0 unknown protocol drops
>> > 0 babbles, 0 late collision, 0 deferred
>> > 0 lost carrier, 0 no carrier
>> > 0 output buffer failures, 0 output buffers swapped out
>> > Rack1SW2(config-if)#do show version
>> > Cisco IOS Software, 3700 Software (C3725-ADVENTERPRISEK9-M), Version
>> > 12.4(15)T10, RELEASE SOFTWARE (fc3)
>> > Technical Support: http://www.cisco.com/techsupport
>> > Copyright (c) 1986-2009 by Cisco Systems, Inc.
>> > Compiled Mon 14-Sep-09 15:53 by prod_rel_team
>> >
>> >
>> > Blogs and organic groups at http://www.ccie.net
>> >
>> > _______________________________________________________________________
>> > Subscription information may be found at:
>> > http://www.groupstudy.com/list/CCIELab.html
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>>
>>
>> --
>> Best Regards,
>>
>> Tolulope.
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Feb 19 2010 - 19:50:26 ART