Re: L3 etherchannel Dynamips

edmore,
i think bobola is suggesting you to replace the L3 etherchannel with a
simple/single L3 interface.

/R

2010/2/19 Edmore Chingwena <chingwenaed_at_gmail.com>

> Doesnt work tried it
>
> On 19 February 2010 18:54, Bobola Oke <okebobola_at_gmail.com> wrote:
>
> > hey edmore,
> > use no switchport command on the individual interfaces first before
> > bundling them up
> > it should work, i think
> >
> > but i dont think you're having dynamips problem
> >
> >
> > On Fri, Feb 19, 2010 at 12:37 PM, Tolulope Ogunsina <togunsina_at_gmail.com
> >wrote:
> >
> >> Hi,
> >> Dynamips does NOT emulate switches or ISRs.
> >> The NM16ESW module is still NOT a switch :-)
> >>
> >> Configuration features of the Etherswitch module are documented here:
> >>
> >>
> >>
> http://www.cisco.com/en/US/docs/ios/lanswitch/configuration/guide/lsw_enet_switch_net_ps6350_TSD_Products_Configuration_Guide_Chapter.html
> >>
> >>
> >> The NM16ESW does not support layer 3 etherchannels.
> >>
> >> On 2/19/10, Edmore Chingwena <chingwenaed_at_gmail.com> wrote:
> >> > Hi Guys
> >> >
> >> > Any help on the issue below I am experiencing any ideas
> >> >
> >> > Rack1SW2(config)#int po2
> >> > Rack1SW2(config-if)#ip address 155.1.108.8 255.255.255.0
> >> >
> >> > % IP addresses may not be configured on L2 links.
> >> >
> >> > Rack1SW2(config-if)#no switchport
> >> > Command rejected: not allowed under port channel.
> >> > Rack1SW2(config-if)#
> >> >
> >> > Rack1SW2(config-if)#do show run int port 2
> >> > Building configuration...
> >> >
> >> > Current configuration : 31 bytes
> >> > !
> >> > interface Port-channel2
> >> > end
> >> >
> >> > Rack1SW2(config-if)#do show run int fa 1/13
> >> > Building configuration...
> >> >
> >> > Current configuration : 59 bytes
> >> > !
> >> > interface FastEthernet1/13
> >> > channel-group 2 mode on
> >> > end
> >> >
> >> > Rack1SW2(config-if)#do show run int fa 1/14
> >> > Building configuration...
> >> >
> >> > Current configuration : 59 bytes
> >> > !
> >> > interface FastEthernet1/14
> >> > channel-group 2 mode on
> >> > end
> >> >
> >> > Rack1SW2(config-if)#do show run int fa 1/15
> >> > Building configuration...
> >> >
> >> > Current configuration : 59 bytes
> >> > !
> >> > interface FastEthernet1/15
> >> > channel-group 2 mode on
> >> > end
> >> >
> >> > Rack1SW2(config-if)#do show int port 2
> >> > Port-channel2 is up, line protocol is up
> >> > Hardware is EtherChannel, address is c20a.0da8.f10f (bia
> >> c20a.0da8.f10f)
> >> > MTU 1500 bytes, BW 300000 Kbit/sec, DLY 1000 usec,
> >> > reliability 255/255, txload 1/255, rxload 1/255
> >> > Encapsulation ARPA, loopback not set
> >> > Keepalive set (10 sec)
> >> > Auto-duplex, Auto-speed
> >> > Members in this channel: Fa1/13 Fa1/14 Fa1/15
> >> > ARP type: ARPA, ARP Timeout 04:00:00
> >> > Last input 00:00:01, output never, output hang never
> >> > Last clearing of "show interface" counters never
> >> > Input queue: 39/75/370/0 (size/max/drops/flushes); Total output
> drops:
> >> 0
> >> > Queueing strategy: fifo
> >> > Output queue: 0/40 (size/max)
> >> > 5 minute input rate 0 bits/sec, 0 packets/sec
> >> > 5 minute output rate 0 bits/sec, 0 packets/sec
> >> > 0 packets input, 0 bytes, 0 no buffer
> >> > Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
> >> > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
> >> > 0 input packets with dribble condition detected
> >> > 0 packets output, 0 bytes, 0 underruns
> >> > 0 output errors, 0 collisions, 1 interface resets
> >> > 0 unknown protocol drops
> >> > 0 babbles, 0 late collision, 0 deferred
> >> > 0 lost carrier, 0 no carrier
> >> > 0 output buffer failures, 0 output buffers swapped out
> >> > Rack1SW2(config-if)#do show version
> >> > Cisco IOS Software, 3700 Software (C3725-ADVENTERPRISEK9-M), Version
> >> > 12.4(15)T10, RELEASE SOFTWARE (fc3)
> >> > Technical Support: http://www.cisco.com/techsupport
> >> > Copyright (c) 1986-2009 by Cisco Systems, Inc.
> >> > Compiled Mon 14-Sep-09 15:53 by prod_rel_team
> >> >
> >> >
> >> > Blogs and organic groups at http://www.ccie.net
> >> >
> >> >
> _______________________________________________________________________
> >> > Subscription information may be found at:
> >> > http://www.groupstudy.com/list/CCIELab.html
> >> >
> >> >
> >> >
> >> >
> >> >
> >> >
> >> >
> >> >
> >>
> >>
> >> --
> >> Best Regards,
> >>
> >> Tolulope.
> >>
> >>
> >> Blogs and organic groups at http://www.ccie.net
> >>
> >> _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
--
Blogs and organic groups at http://www.ccie.net