Re: leased line with G703 module using router 2851 and 2801

Hi 2,

oh i see, thanks frog. i'll try implementing it.

---
rgds - erwin
----- Original Message ----- 
From: Radioactive Frog
To: erwin wijaya
Cc: ccielab_at_groupstudy.com
Sent: Tuesday, June 30, 2009 8:39 PM
Subject: Re: leased line with G703 module using router 2851 and 2801
Hi Erwin,It's damn easy!controller E1 2/0
channel-group 0 unframedafter issuing above command the router creates a 
logical serial interface where you can put your WAN ip, just like you've 
seen serial port.assign ip here for wan side of thigns.
interface Serial2/0:0
ip address 1.1.1.1 255.255.255.0
verify by using 'show controller e1 1/0 and show inter serial2/0:0"HTH-frog
On Tue, Jun 30, 2009 at 5:33 PM, erwin wijaya <erwinem.wijaya_at_gmail.com> 
wrote:
dear all,
how to configure my router when i need to connecting my office (router 2851) 
with branch office (router 2801) using G703 module. We are using leased line 
conection to connecting both office. Also we'll use to send data and 
voice..present we using MPLS tech to connecting both office. Is it the same 
way?
thanks alot for any helps.
regards - erwin
Blogs and organic groups at http://www.ccie.net