Re: leased line with G703 module using router 2851 and 2801

well if that is the requirement, you were better off with the
MPLS........leased lines dont work that way....

On Wed, Jul 15, 2009 at 1:37 PM, erwin wijaya <erwinem.wijaya_at_gmail.com>wrote:

> Hi again,
>
> Is it possible at central site only using 1 router and 1 vwic G703? coz,
> all branch office connected leased line to central site. so we just adding
> 1 card G703 per branch?
>
> thanks again..
> regards-Erwin
>
>
>
> Radioactive Frog wrote:
>
>> u only need 1 routerat the central site wiht 3 serial or E1 interface
>> (depends where E1 line terminates). If its close to (within 120
>> meters) PDH/SDH MuX use E1 else u may need to use a e1 extender
>> convertor.
>>
>>
>> On 7/7/09, erwinem wijaya <erwinem.wijaya_at_gmail.com> wrote:
>>
>>
>>> Hi all,
>>> another questions, for example i need to connecting office B to A, also
>>> ofice C to A, and office D to A. office A is a central office. do wee
>>> need 3
>>> router at office A or we just need 1 router at office A if we'll using
>>> leased line. Today we using 1 router for 3 branch office with MPLS.
>>>
>>> thanks for any helps.
>>>
>>> ----- Original Message -----
>>> From: Radioactive Frog
>>> To: erwin wijaya
>>> Cc: ccielab_at_groupstudy.com
>>> Sent: Tuesday, June 30, 2009 8:39 PM
>>> Subject: Re: leased line with G703 module using router 2851 and 2801
>>>
>>>
>>> Hi Erwin,It's damn easy!controller E1 2/0channel-group 0 unframedafter
>>> issuing above command the router creates a logical serial interface where
>>> you can put your WAN ip, just like you've seen serial port.assign ip here
>>> for wan side of thigns.
>>> interface Serial2/0:0ip address 1.1.1.1 255.255.255.0verify by using
>>> 'show
>>> controller e1 1/0 and show inter serial2/0:0"HTH-frog
>>>
>>> On Tue, Jun 30, 2009 at 5:33 PM, erwin wijaya <erwinem.wijaya_at_gmail.com
>>> >
>>> wrote:
>>>
>>> dear all,
>>> how to configure my router when i need to connecting my office (router
>>> 2851) with branch office (router 2801) using G703 module. We are using
>>> leased line conection to connecting both office. Also we'll use to send
>>> data
>>> and voice..present we using MPLS tech to connecting both office. Is it
>>> the
>>> same way?
>>>
>>> thanks alot for any helps.
>>> regards - erwin
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>>>
>>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Best Regards
Mohammed Abdul Razzaq
If you are not small enough to loose, you are not big enough to win..
Blogs and organic groups at http://www.ccie.net