Re: leased line with G703 module using router 2851 and 2801

framed vs unframed

On 7/7/09, jack daniels <jckdaniels12_at_gmail.com> wrote:
> Hi,
>
> I have a qurry over here -- sometimes we configure IP ADDRESS on
>
> chanell 0
> SERIAL 2/0:0
>
> and sometimes on
> channel 15
> SERIAL 2/0:15
>
> why so ?
>
>
> Thanks and Regards
> J.Daniels
> On Tue, Jun 30, 2009 at 7:09 PM, Radioactive Frog
> <pbhatkoti_at_gmail.com>wrote:
>
>> Hi Erwin,
>> It's damn easy!
>>
>> controller E1 2/0
>>
>> channel-group 0 unframed
>>
>> after issuing above command the router creates a logical serial
>> interface where you can put your WAN ip, just like you've seen serial
>> port.
>> assign ip here for wan side of thigns.
>>
>> interface Serial2/0:0
>>
>> ip address 1.1.1.1 255.255.255.0
>>
>>
>> verify by using 'show controller e1 1/0 and show inter serial2/0:0"
>> HTH
>> -frog
>>
>>
>> On Tue, Jun 30, 2009 at 5:33 PM, erwin wijaya <erwinem.wijaya_at_gmail.com
>> >wrote:
>>
>> > dear all,
>> > how to configure my router when i need to connecting my office (router
>> > 2851) with branch office (router 2801) using G703 module. We are using
>> > leased line conection to connecting both office. Also we'll use to send
>> data
>> > and voice..present we using MPLS tech to connecting both office. Is it
>> the
>> > same way?
>> >
>> > thanks alot for any helps.
>> > regards - erwin
>> >
>> >
>> > Blogs and organic groups at http://www.ccie.net
>> >
>> > _______________________________________________________________________
>> > Subscription information may be found at:
>> > http://www.groupstudy.com/list/CCIELab.html
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 07 2009 - 22:38:13 ART