Re: leased line with G703 module using router 2851 and 2801

that's great!....
would u like to show me how to config my router coz i need time to learn
it before, coz in near time we'll doing that.

thanks again
regards -ew

----
Radioactive Frog wrote:
> yes that is possible. Your lease line provider should map your 
> individual 2 megs timeslots to all remote site using a MUX.
> In central site u can just use one interface with frame-relay 
> point-to-multipoint subinterface.
>
>
> On Wed, Jul 15, 2009 at 8:02 PM, Mohammed Naviwala <monavy_at_gmail.com 
> <mailto:monavy_at_gmail.com>> wrote:
>
>     well if that is the requirement, you were better off with the
>     MPLS........leased lines dont work that way....
>
>
>     On Wed, Jul 15, 2009 at 1:37 PM, erwin wijaya
>     <erwinem.wijaya_at_gmail.com <mailto:erwinem.wijaya_at_gmail.com>> wrote:
>
>         Hi again,
>
>         Is it possible at central site only using 1 router and 1 vwic
>         G703? coz, all branch office connected  leased line to central
>         site. so we just adding 1 card G703 per branch?
>
>         thanks again..
>         regards-Erwin
>
>
>
>         Radioactive Frog wrote:
>
>             u only need 1 routerat the central site wiht 3 serial or
>             E1 interface
>             (depends where E1 line terminates). If its close to
>             (within 120
>             meters) PDH/SDH MuX use E1 else u may need to use a e1
>             extender
>             convertor.
>
>
>             On 7/7/09, erwinem wijaya <erwinem.wijaya_at_gmail.com
>             <mailto:erwinem.wijaya_at_gmail.com>> wrote:
>              
>
>                 Hi all,
>                 another questions, for example i need to connecting
>                 office B to A, also
>                 ofice C to A, and office D to A. office A is a central
>                 office. do wee need 3
>                 router at office A or we just need 1 router at office
>                 A if we'll using
>                 leased line. Today we using 1 router for 3 branch
>                 office with MPLS.
>
>                 thanks for any helps.
>
>                  ----- Original Message -----
>                  From: Radioactive Frog
>                  To: erwin wijaya
>                  Cc: ccielab_at_groupstudy.com
>                 <mailto:ccielab_at_groupstudy.com>
>                  Sent: Tuesday, June 30, 2009 8:39 PM
>                  Subject: Re: leased line with G703 module using
>                 router 2851 and 2801
>
>
>                 Hi Erwin,It's damn easy!controller E1 2/0channel-group
>                 0 unframedafter
>                 issuing above command the router creates a logical
>                 serial interface where
>                 you can put your WAN ip, just like you've seen serial
>                 port.assign ip here
>                 for wan side of thigns.
>                 interface Serial2/0:0ip address 1.1.1.1
>                 255.255.255.0verify by using 'show
>                 controller e1 1/0 and show inter serial2/0:0"HTH-frog
>
>                  On Tue, Jun 30, 2009 at 5:33 PM, erwin wijaya
>                 <erwinem.wijaya_at_gmail.com
>                 <mailto:erwinem.wijaya_at_gmail.com>>
>                 wrote:
>
>                    dear all,
>                    how to configure my router when i need to
>                 connecting my office (router
>                 2851) with branch office (router 2801) using G703
>                 module. We are using
>                 leased line conection to connecting both office. Also
>                 we'll use to send data
>                 and voice..present we using MPLS tech to connecting
>                 both office. Is it the
>                 same way?
>
>                    thanks alot for any helps.
>                    regards - erwin
>
>
>                    Blogs and organic groups at http://www.ccie.net
>
>                  
>                  _______________________________________________________________________
>                    Subscription information may be found at:
>                 http://www.groupstudy.com/list/CCIELab.html
>
>
>
>         Blogs and organic groups at http://www.ccie.net
>
>         _______________________________________________________________________
>         Subscription information may be found at:
>         http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>
>
>
>     -- 
>     Best Regards
>
>     Mohammed Abdul Razzaq
>
>
>     If you are not small enough to loose, you are not big enough to win..
Blogs and organic groups at http://www.ccie.net