From: Udo Konstantin (ccie_groupstudy@yahoo.de)
Date: Sun Aug 20 2006 - 16:57:44 ART
Hi all,
today I want to configure a dynamik acl.
Following the cco doc I should configure
===========================
line vty 0
login local
autocommand access-enable timeout 5
=============================
-->> this is not possible
see the output below..
Rack1R3(config-line)#autocommand ?
LINE Appropriate EXEC command
no-suppress-linenumber Display service linenumber message
Rack1R3(config-line)#autocommand-
Rack1R3(config-line)#autocommand-options ?
abort-character Autocommand abort character
delay Delay autocommand execution
nohangup No hangup after autocommand completion
<cr>
So where can I set the idle timeout ??
And also why should I configure access-group in at the ethernet
interface ?
I only want to restrict access on the line vty 0 4
Udo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART