From: Sohail Bhamani (sohail@gmail.com)
Date: Sun Aug 20 2006 - 18:12:01 ART
Right. This is a hidden command. Just try it out and it will work.
On 8/20/06, Aamir Aziz <aamiraz77@gmail.com> wrote:
>
> Hi just type the command as it is and the router will accept it will not
> show when you do ?.
>
> aamir
>
>
> On 8/20/06, Udo Konstantin <ccie_groupstudy@yahoo.de> wrote:
> >
> > Hi all,
> >
> > today I want to configure a dynamik acl.
> > Following the cco doc I should configure
> >
> > ===========================
> > line vty 0
> > login local
> > autocommand access-enable timeout 5
> > =============================
> > -->> this is not possible
> > see the output below..
> >
> >
> >
> > Rack1R3(config-line)#autocommand ?
> > LINE Appropriate EXEC command
> > no-suppress-linenumber Display service linenumber message
> >
> > Rack1R3(config-line)#autocommand-
> > Rack1R3(config-line)#autocommand-options ?
> > abort-character Autocommand abort character
> > delay Delay autocommand execution
> > nohangup No hangup after autocommand completion
> > <cr>
> >
> > So where can I set the idle timeout ??
> > And also why should I configure access-group in at the ethernet
> > interface ?
> > I only want to restrict access on the line vty 0 4
> >
> > Udo
> >
> >
> >
> >
> > ___________________________________________________________
> > Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART