From: Guzman, Chris (Chris.Guzman@McKesson.com)
Date: Sun Aug 20 2006 - 18:35:59 ART
The access-enable is an EXEC level command that will not show with the
?, since any EXEC command is available for use with the autocommand.
It enables the dynamic ACL entry for the lock and key ACL.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Udo Konstantin
Sent: Sunday, August 20, 2006 12:58 PM
To: CCIE Groupstudy
Subject: Lock and Key Access List
Hi all,
today I want to configure a dynamik acl.
Following the cco doc I should configure
===========================
line vty 0
login local
autocommand access-enable timeout 5
=============================
-->> this is not possible
see the output below..
Rack1R3(config-line)#autocommand ?
LINE Appropriate EXEC command
no-suppress-linenumber Display service linenumber message
Rack1R3(config-line)#autocommand-
Rack1R3(config-line)#autocommand-options ?
abort-character Autocommand abort character
delay Delay autocommand execution
nohangup No hangup after autocommand completion
<cr>
So where can I set the idle timeout ??
And also why should I configure access-group in at the ethernet
interface ?
I only want to restrict access on the line vty 0 4
Udo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART