From: Aamir Aziz (aamiraz77@gmail.com)
Date: Sun Aug 20 2006 - 17:45:01 ART
Hi just type the command as it is and the router will accept it will not
show when you do ?.
aamir
On 8/20/06, Udo Konstantin <ccie_groupstudy@yahoo.de> wrote:
>
> Hi all,
>
> today I want to configure a dynamik acl.
> Following the cco doc I should configure
>
> ===========================
> line vty 0
> login local
> autocommand access-enable timeout 5
> =============================
> -->> this is not possible
> see the output below..
>
>
>
> Rack1R3(config-line)#autocommand ?
> LINE Appropriate EXEC command
> no-suppress-linenumber Display service linenumber message
>
> Rack1R3(config-line)#autocommand-
> Rack1R3(config-line)#autocommand-options ?
> abort-character Autocommand abort character
> delay Delay autocommand execution
> nohangup No hangup after autocommand completion
> <cr>
>
> So where can I set the idle timeout ??
> And also why should I configure access-group in at the ethernet
> interface ?
> I only want to restrict access on the line vty 0 4
>
> Udo
>
>
>
>
> ___________________________________________________________
> Telefonate ohne weitere Kosten vom PC zum PC: http://messenger.yahoo.de
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART