From: Plank, Jason (JPlank@concordefs.com)
Date: Sun Aug 20 2006 - 17:21:41 ART
Did you try entering the command as is?
I can't go into to many details, but let me just say that I had the same
issue and just entered the command and it took. I never went back and looked
up why it appeared to be a hidden command but since I passed I had no real
motivation to go back :)
-------------------
Jason Plank, CCIE #16560
Network Engineer
101 Bellevue Parkway
Wilmington, DE 19809
E-mail: JPlank@concordefs.com
Phone: 302-793-5913
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Udo
Konstantin
Sent: Sunday, August 20, 2006 3:58 PM
To: CCIE Groupstudy
Subject: Lock and Key Access List
Hi all,
today I want to configure a dynamik acl.
Following the cco doc I should configure
===========================
line vty 0
login local
autocommand access-enable timeout 5
=============================
-->> this is not possible
see the output below..
Rack1R3(config-line)#autocommand ?
LINE Appropriate EXEC command
no-suppress-linenumber Display service linenumber message
Rack1R3(config-line)#autocommand-
Rack1R3(config-line)#autocommand-options ?
abort-character Autocommand abort character
delay Delay autocommand execution
nohangup No hangup after autocommand completion
<cr>
So where can I set the idle timeout ??
And also why should I configure access-group in at the ethernet
interface ?
I only want to restrict access on the line vty 0 4
Udo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:57 ART