VOIP (DID)

From: Hung, Sing-Yu (Sing-Yu.Hung@xxxxxxxx)
Date: Sat Aug 17 2002 - 09:34:04 GMT-3

• Next message: kym blair: "RE: Help: Cisco 2924M-XL"
• Previous message: K Sarangan: "Bridging."
• Next in thread: Tony H.: "Re: VOIP (DID)"
• Maybe reply: Tony H.: "Re: VOIP (DID)"
• Maybe reply: CCIE Prep: "RE: VOIP (DID)"
• Maybe reply: Dotun Oni: "Re: VOIP (DID)"
• Maybe reply: Raymond Jett: "RE: VOIP (DID)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Dear,

        I have the below diagram and r1 config
r1(10.4.1.1)--------------(10.4.1.2)r2

r1(config):
voice-port 1/0
!
voice-port 1/1
!
!
dial-peer voice 2 voip
 destination-pattern 5919696
 session target ipv4:10.4.1.2
!
dial-peer voice 3 voip
 destination-pattern 3600
 session target ipv4:10.4.1.2
!
dial-peer voice 1 pots
 destination-pattern 1000
 direct-inward-dial
 port 1/0

the question is I can't config DID on r1 and I just get a "busy tone" when I
pick up the phone on r1. So can anyone tell me how to config DID. And I
don't know how to config and how to use "incoming called-number " and
"answer-address". Please tell me. THX

Bradford Hung

> Pacific Century CyberWorks
> Tel: 288 33125

• Next message: kym blair: "RE: Help: Cisco 2924M-XL"
• Previous message: K Sarangan: "Bridging."
• Next in thread: Tony H.: "Re: VOIP (DID)"
• Maybe reply: Tony H.: "Re: VOIP (DID)"
• Maybe reply: CCIE Prep: "RE: VOIP (DID)"
• Maybe reply: Dotun Oni: "Re: VOIP (DID)"
• Maybe reply: Raymond Jett: "RE: VOIP (DID)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:27 GMT-3