From: Raymond Jett (rajett@xxxxxxxxx)
Date: Sat Aug 17 2002 - 17:11:03 GMT-3
Make sure you have a voice port that handles DID...
There is only one analog VIC that supports it: VIC-2DID, but you should be
OK using DID with digital.
Keep in mind that the VIC-2DID only does DID calls, no outbound calls.
http://www.cisco.com/warp/public/788/products/vic-2did.html
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122
t/122t2/dt_did.htm
Raymond
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
CCIE Prep
Sent: Saturday, August 17, 2002 1:08 PM
To: 'Hung, Sing-Yu'; 'CCIElab@groupstudy.com'
Subject: RE: VOIP (DID)
Couple questions for you in order to help you out:
1) What kind of voice-port is 1/0 and 1/1? FXO/FXS/E&M?
2) What are they connected to?
3) You say you are getting a busy tone when you pick up the phone, are you
trying to configure a Private Line Auto Ringdown (PLAR) connection?
4) What digits are being sent to you in order to route as a DID?
Thanx
Nate Kleven
-----Original Message-----
From: Hung, Sing-Yu [mailto:Sing-Yu.Hung@pccw.com]
Sent: Saturday, August 17, 2002 5:34 AM
To: ccielab@groupstudy.com
Subject: VOIP (DID)
Dear,
I have the below diagram and r1 config
r1(10.4.1.1)--------------(10.4.1.2)r2
r1(config):
voice-port 1/0
!
voice-port 1/1
!
!
dial-peer voice 2 voip
destination-pattern 5919696
session target ipv4:10.4.1.2
!
dial-peer voice 3 voip
destination-pattern 3600
session target ipv4:10.4.1.2
!
dial-peer voice 1 pots
destination-pattern 1000
direct-inward-dial
port 1/0
the question is I can't config DID on r1 and I just get a "busy tone" when I
pick up the phone on r1. So can anyone tell me how to config DID. And I
don't know how to config and how to use "incoming called-number " and
"answer-address". Please tell me. THX
Bradford Hung
> Pacific Century CyberWorks
> Tel: 288 33125
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:27 GMT-3