From: Dotun Oni (dot_oni@xxxxxxxxxxx)
Date: Sat Aug 17 2002 - 15:19:50 GMT-3
http://www.cisco.com/warp/public/788/voip/direct_inward_dial.html
>From: "Hung, Sing-Yu" <Sing-Yu.Hung@pccw.com>
>Reply-To: "Hung, Sing-Yu" <Sing-Yu.Hung@pccw.com>
>To: ccielab@groupstudy.com
>Subject: VOIP (DID)
>Date: Sat, 17 Aug 2002 20:34:04 +0800
>
>Dear,
>
> I have the below diagram and r1 config
>r1(10.4.1.1)--------------(10.4.1.2)r2
>
>r1(config):
>voice-port 1/0
>!
>voice-port 1/1
>!
>!
>dial-peer voice 2 voip
> destination-pattern 5919696
> session target ipv4:10.4.1.2
>!
>dial-peer voice 3 voip
> destination-pattern 3600
> session target ipv4:10.4.1.2
>!
>dial-peer voice 1 pots
> destination-pattern 1000
> direct-inward-dial
> port 1/0
>
>the question is I can't config DID on r1 and I just get a "busy tone" when
>I
>pick up the phone on r1. So can anyone tell me how to config DID. And I
>don't know how to config and how to use "incoming called-number " and
>"answer-address". Please tell me. THX
>
>
>Bradford Hung
>
> > Pacific Century CyberWorks
> > Tel: 288 33125
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:27 GMT-3