From: Tony H. (aamercado31@xxxxxxxxx)
Date: Sat Aug 17 2002 - 15:08:56 GMT-3
Check out:
http://www.cisco.com/warp/public/788/voip/direct_inward_dial.html
--- "Hung, Sing-Yu" <Sing-Yu.Hung@pccw.com> wrote:
> Dear,
>
> I have the below diagram and r1 config
> r1(10.4.1.1)--------------(10.4.1.2)r2
>
> r1(config):
> voice-port 1/0
> !
> voice-port 1/1
> !
> !
> dial-peer voice 2 voip
> destination-pattern 5919696
> session target ipv4:10.4.1.2
> !
> dial-peer voice 3 voip
> destination-pattern 3600
> session target ipv4:10.4.1.2
> !
> dial-peer voice 1 pots
> destination-pattern 1000
> direct-inward-dial
> port 1/0
>
> the question is I can't config DID on r1 and I just
> get a "busy tone" when I
> pick up the phone on r1. So can anyone tell me how
> to config DID. And I
> don't know how to config and how to use "incoming
> called-number " and
> "answer-address". Please tell me. THX
>
>
> Bradford Hung
>
> > Pacific Century CyberWorks
> > Tel: 288 33125
>
This archive was generated by hypermail 2.1.4 : Sat Sep 07 2002 - 19:48:27 GMT-3