From: Mark Lewis (markl11@xxxxxxxxxxx)
Date: Thu Sep 28 2000 - 11:24:23 GMT-3
Hi Gurus,
ATM SVCs WITHOUT ILMI.
----------------------
Wonder if you can offer a little help.
I've been configuring atm svcs using the 'atm esi-address' command without
any problems (this command requires the use of ilmi).
However, if I'm not allowed to use ilmi (no atm pvc 1 0 16 ilmi) then it
seems to me that the command I need is 'atm nsap-address'. Now I know that
these two commands do bascially the same thing (but 'atm esi-address' allows
you to be slightly lazier (very appealing!)), but in the Cisco IOS WAN
Networking Solutions manual (the one for 11.x) it strongly implies that the
'..nsap-addr..' command CAN be used without ilmi.
Now here's the crux of the problem: I can't get it to work!
My config is very simple, two routers either side of ls1010, both with
approximately the following config:
int atm0/0
atm pvc 1 0 5 qsaal
atm nsap-address xxx(prefix)xxx.123456789012.00
ip address xxxxx yyyyy
ESI is of course unique on each router.
Now the moment I use '..esi-address' & ilmi, it starts working.
So, how do I get SVCs WITHOUT ilmi to work???
Thanks v.much in advance,
Mark
P.S. I know that it's possible to get it to work by turning on ilmi
temporarily (so that prefix & esi are exchanged), but I need a real
solution.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:08 GMT-3