EIGRP over FRAME_RELAY

Hi Dears,

I have issue with eigrp over frame-relay, I have
four router connected to each other ( full mesh )

R2-------R4
R5-------R6

R2,R5,R6 : using the multipoint sub interfaces
R4 : using the physical interface

-All the frame-maps configured correctly, I have the reachablitly between all
of them.

-R2: all the neighbors came up
-R5: showed the neighbors to R2,R6
-R6: showed the neighbors to R2,R5

-R4: showed the neighbors to all of them but there was flapping to R5,R6!
The flapping showed on R4 only,the flapped didn't appear on both R5,R6.As i
know the flapped
should appear on both side of the neighborship.
ON R4 it gave me console message *RETRY LIMIT EXCEEDED*

I disabled the split-horizon on R2,R4,R5,R6

R2,R5,R6 :disabled on the sub-interfaces
R4 : disabled on the phyiscal interface.

I tried to disable the split-horizon on the phyiscal interfaces for all
routers, but without any luck.

Any ideas/suggestions will highly appreciated !!

Thanks in advance.

Blogs and organic groups at http://www.ccie.net
Received on Fri Jun 15 2012 - 12:44:03 ART