RE: EIGRP over FRAME_RELAY

First, don't get dinged for using too many commands - you only need no ip split-horizon on the interface with the ip... (the sub-interface for R2,R5,R6).

Split horizon won't stop them from neighboring up - just from accepting the top table it learns from that neighbor.

Post your frsw configs or if this is a dynamips backed scenario - adjust your cpu idle values - your rig might not be built out correctly to support dynamips.

>-All the frame-maps configured correctly, I have the reachablitly between all of them.

Did you remember the "BROADCAST" keyword on R4's maps?

LOL

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of mohd-mousa_at_hotmail.com
Sent: Friday, June 15, 2012 12:44 PM
To: ccielab_at_groupstudy.com
Subject: EIGRP over FRAME_RELAY

Hi Dears,

I have issue with eigrp over frame-relay, I have four router connected to each other ( full mesh )

R2-------R4
R5-------R6

R2,R5,R6 : using the multipoint sub interfaces
R4 : using the physical interface

-All the frame-maps configured correctly, I have the reachablitly between all of them.

-R2: all the neighbors came up
-R5: showed the neighbors to R2,R6
-R6: showed the neighbors to R2,R5

-R4: showed the neighbors to all of them but there was flapping to R5,R6!
The flapping showed on R4 only,the flapped didn't appear on both R5,R6.As i know the flapped should appear on both side of the neighborship.
ON R4 it gave me console message *RETRY LIMIT EXCEEDED*

I disabled the split-horizon on R2,R4,R5,R6

R2,R5,R6 :disabled on the sub-interfaces
R4 : disabled on the phyiscal interface.

I tried to disable the split-horizon on the phyiscal interfaces for all routers, but without any luck.

Any ideas/suggestions will highly appreciated !!

Thanks in advance.

Blogs and organic groups at http://www.ccie.net
Received on Fri Jun 15 2012 - 17:09:11 ART