RE: EIGRP over FRAME_RELAY

Hi Joe, I did this on real devices, not on dynamips :))) Thanks
> From: joe_at_affirmedsystems.com
> To: mohd-mousa_at_hotmail.com; ccielab_at_groupstudy.com
> Subject: RE: EIGRP over FRAME_RELAY
> Date: Fri, 15 Jun 2012 17:09:11 +0000
>
> First, don't get dinged for using too many commands - you only need no ip split-horizon on the interface with the ip... (the sub-interface for R2,R5,R6).
>
> Split horizon won't stop them from neighboring up - just from accepting the top table it learns from that neighbor.
>
> Post your frsw configs or if this is a dynamips backed scenario - adjust your cpu idle values - your rig might not be built out correctly to support dynamips.
>
> >-All the frame-maps configured correctly, I have the reachablitly between all of them.
>
> Did you remember the "BROADCAST" keyword on R4's maps?
>
> LOL
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of mohd-mousa_at_hotmail.com
> Sent: Friday, June 15, 2012 12:44 PM
> To: ccielab_at_groupstudy.com
> Subject: EIGRP over FRAME_RELAY
>
> Hi Dears,
>
> I have issue with eigrp over frame-relay, I have four router connected to each other ( full mesh )
>
> R2-------R4
> R5-------R6
>
> R2,R5,R6 : using the multipoint sub interfaces
> R4 : using the physical interface
>
> -All the frame-maps configured correctly, I have the reachablitly between all of them.
>
> -R2: all the neighbors came up
> -R5: showed the neighbors to R2,R6
> -R6: showed the neighbors to R2,R5
>
> -R4: showed the neighbors to all of them but there was flapping to R5,R6!
> The flapping showed on R4 only,the flapped didn't appear on both R5,R6.As i know the flapped should appear on both side of the neighborship.
> ON R4 it gave me console message *RETRY LIMIT EXCEEDED*
>
>
> I disabled the split-horizon on R2,R4,R5,R6
>
> R2,R5,R6 :disabled on the sub-interfaces
> R4 : disabled on the phyiscal interface.
>
> I tried to disable the split-horizon on the phyiscal interfaces for all routers, but without any luck.
>
> Any ideas/suggestions will highly appreciated !!
>
>
> Thanks in advance.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Jun 15 2012 - 18:21:28 ART