Re: EIGRP over FRAME_RELAY

Guys Any update here ?

Sent from my iPhone

On Jun 15, 2012, at 8:02 PM, mohd-mousa_at_hotmail.com wrote:

> Hi Dears,
>
> I have issue with eigrp over frame-relay, I have
> four router connected to each other ( full mesh )
>
> R2-------R4
> R5-------R6
>
> R2,R5,R6 : using the multipoint sub interfaces
> R4 : using the physical interface
>
> -All the frame-maps configured correctly, I have the reachablitly between all
> of them.
>
> -R2: all the neighbors came up
> -R5: showed the neighbors to R2,R6
> -R6: showed the neighbors to R2,R5
>
> -R4: showed the neighbors to all of them but there was flapping to R5,R6!
> The flapping showed on R4 only,the flapped didn't appear on both R5,R6.As i
> know the flapped
> should appear on both side of the neighborship.
> ON R4 it gave me console message *RETRY LIMIT EXCEEDED*
>
>
> I disabled the split-horizon on R2,R4,R5,R6
>
> R2,R5,R6 :disabled on the sub-interfaces
> R4 : disabled on the phyiscal interface.
>
> I tried to disable the split-horizon on the phyiscal interfaces for all
> routers, but without any luck.
>
> Any ideas/suggestions will highly appreciated !!
>
>
> Thanks in advance.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sat Jun 16 2012 - 18:38:42 ART