Frame Switch Issue

Group,

Ran into an issue with NM A/S card. It shows up, but all interfaces state
down/down. Am I missing something obvious?

interface Serial0/0/0
 description R1
 no ip address
 encapsulation frame-relay
 no fair-queue
 frame-relay intf-type dce
 frame-relay route 102 interface Serial0/1/0 201
 frame-relay route 103 interface Serial1/0 301
 frame-relay route 104 interface Serial1/1 401
 frame-relay route 105 interface Serial1/2 501
 frame-relay route 106 interface Serial1/3 601
 frame-relay route 112 interface Serial0/1/0 211
!
interface Serial0/1/0
 description R2
 no ip address
 encapsulation frame-relay
 no fair-queue
 clock rate 2000000
 frame-relay intf-type dce
 frame-relay route 201 interface Serial0/0/0 102
 frame-relay route 202 interface Serial0/2/0 302
 frame-relay route 204 interface Serial1/0 402
 frame-relay route 205 interface Serial1/1 502
 frame-relay route 206 interface Serial1/2 602
!
interface Serial0/2/0
 description R3
 no ip address
 encapsulation frame-relay
 no fair-queue
 clock rate 2000000
 frame-relay intf-type dce
 frame-relay route 301 interface Serial0/0/0 102
 frame-relay route 302 interface Serial0/1/0 203
 frame-relay route 304 interface Serial1/0 403
 frame-relay route 305 interface Serial1/1 503
 frame-relay route 306 interface Serial1/2 603
!
interface Serial1/0
 description R4
 no ip address
 encapsulation frame-relay
 no fair-queue
 clock rate 64000
 dce-terminal-timing-enable
 frame-relay intf-type dce
 frame-relay route 401 interface Serial0/0/0 104
 frame-relay route 402 interface Serial0/1/0 204
 frame-relay route 403 interface Serial0/2/0 304
 frame-relay route 405 interface Serial1/1 504
 frame-relay route 406 interface Serial1/2 604
!
interface Serial1/1
 description R5
 no ip address
 encapsulation frame-relay
 no fair-queue
 clock rate 128000
 no dce-terminal-timing-enable
 frame-relay intf-type dce
 frame-relay route 501 interface Serial0/0/0 105
 frame-relay route 502 interface Serial0/1/0 205
 frame-relay route 503 interface Serial0/2/0 305
 frame-relay route 504 interface Serial1/0 405
 frame-relay route 506 interface Serial1/2 605
!
interface Serial1/2
 description R6
 no ip address
 encapsulation frame-relay
 no fair-queue
 clock rate 128000
 no dce-terminal-timing-enable
 frame-relay intf-type dce
 frame-relay route 601 interface Serial0/0/0 106
 frame-relay route 602 interface Serial0/1/0 206
 frame-relay route 603 interface Serial0/2/0 306
 frame-relay route 604 interface Serial1/0 406
 frame-relay route 605 interface Serial1/1 506

Interface IP-Address OK? Method Status
 Protocol
GigabitEthernet0/0 unassigned YES NVRAM administratively down
down
GigabitEthernet0/1 unassigned YES NVRAM administratively down
down
Serial0/0/0 unassigned YES NVRAM up
 up
Serial0/1/0 unassigned YES NVRAM up
 up
Serial0/2/0 unassigned YES NVRAM up
 up
Serial1/0 unassigned YES manual down
 down
Serial1/1 unassigned YES NVRAM down
 down
Serial1/2 unassigned YES NVRAM down
 down
Serial1/3 unassigned YES NVRAM down
 down

~~~~~~~~~~Does Not Work~~~~~~~~~~
FRS#sh controllers serial1/0
CD2430 Slot 1, Port 0, Controller 0, Channel 0, Revision 19
Channel mode is synchronous serial
idb 0x468CA034, buffer size 1524, V.35 DCE cable, clockrate 64000

Serial1/0 is down, line protocol is down
  Hardware is CD2430 in sync mode
  Description: R4
  MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation FRAME-RELAY, loopback not set
  Keepalive set (10 sec)
  LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0
  LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0, DCE LMI down
  LMI DLCI 1023 LMI type is CISCO frame relay DCE
  FR SVC disabled, LAPF state down
  Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0
  Last input never, output never, output hang never
  Last clearing of "show interface" counters 00:17:34
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 35 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up DSR=up DTR=down RTS=down CTS=up

~~~~~~~~~~WORKS~~~~~~~~~~~~~~~~
FRS#sh controllers serial0/0/0
Interface Serial0/0/0
Hardware is GT96K
DTE V.35idb at 0x468AAC78, driver data structure at 0x468B23AC
wic_info 0x468B29C0
Physical Port 1, SCC Num 1

Serial0/0/0 is up, line protocol is up
  Hardware is GT96K Serial
  Description: R1
  MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation FRAME-RELAY, loopback not set
  Keepalive set (10 sec)
  LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0
  LMI enq recvd 218, LMI stat sent 218, LMI upd sent 0, DCE LMI up
  LMI DLCI 1023 LMI type is CISCO frame relay DCE
  FR SVC disabled, LAPF state down
  Broadcast queue 0/64, broadcasts sent/dropped 0/0, interface broadcasts 0
  Last input 00:00:08, output 00:00:08, output hang never
  Last clearing of "show interface" counters 00:36:22
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     218 packets input, 2834 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     218 packets output, 4658 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 output buffer failures, 0 output buffers swapped out
     0 carrier transitions
     DCD=up DSR=up DTR=up RTS=up CTS=up

Thanks,

-- 
Dennis Worth
"Of all men's miseries the bitterest it this: to know so much and to have
control over nothing."
--Herodotus
Blogs and organic groups at http://www.ccie.net