Re: Frame Switch Issue

He asks me every night to teach him something new. I taught him on Monday to
do subnetting and convert dotted decimal to binary to HEX, and then do in
reverse. Pretty cool that he was doing it faster than me.

On Thu, May 19, 2011 at 2:18 PM, Ryan West <rwest_at_zyedge.com> wrote:

> On Thu, May 19, 2011 at 17:13:35, Dennis Worth wrote:
> > Cc: Narbik Kocharians; Cisco certification
> > Subject: Re: Frame Switch Issue
> >
> > Ok guys,
> >
> > I have it figured out! I had to drive all the way home, because this
> > didn't make any sense. Device were all powered on and connected, but
> > not working on those interfaces. I turned on all interface on all
> > routers to verify it was all of the router on the NM card 1st, and
> > found R6 was fine. I started checking the controllers on end routers
> > and finding cables not found, but I knew they plugged in. To make a
> > long story short, it was only router 4 and 5
> > S0/0 that the Serial Cables were upside down.
> >
> > Go figure, I didn't even think that was possible. Better yet, This
> > cabling setup was done by my 11 year old son, and he told me it was
> > perfect, except I found a ethernet cable in the wrong place for one of
> > my backbone routers a few weeks ago. Now I have to tell him that he
> > had 4 mistakes including the cable end swapped on R1 frame connection
> > (BTW still works that way), but I guess that's no that bad for his first
> time doing it.
> >
> >
>
> He just failed Day 2 of the lab, I'll have to start my 7 year on
> preparations soon as well.
>
> -ryan
>

-- 
Dennis Worth
"Of all men's miseries the bitterest it this: to know so much and to have
control over nothing."
--Herodotus
Blogs and organic groups at http://www.ccie.net