RE: Frame Switch Issue

On Thu, May 19, 2011 at 17:13:35, Dennis Worth wrote:
> Cc: Narbik Kocharians; Cisco certification
> Subject: Re: Frame Switch Issue
>
> Ok guys,
>
> I have it figured out! I had to drive all the way home, because this
> didn't make any sense. Device were all powered on and connected, but
> not working on those interfaces. I turned on all interface on all
> routers to verify it was all of the router on the NM card 1st, and
> found R6 was fine. I started checking the controllers on end routers
> and finding cables not found, but I knew they plugged in. To make a
> long story short, it was only router 4 and 5
> S0/0 that the Serial Cables were upside down.
>
> Go figure, I didn't even think that was possible. Better yet, This
> cabling setup was done by my 11 year old son, and he told me it was
> perfect, except I found a ethernet cable in the wrong place for one of
> my backbone routers a few weeks ago. Now I have to tell him that he
> had 4 mistakes including the cable end swapped on R1 frame connection
> (BTW still works that way), but I guess that's no that bad for his first time doing it.
>
>

He just failed Day 2 of the lab, I'll have to start my 7 year on preparations soon as well.

-ryan

Blogs and organic groups at http://www.ccie.net
Received on Thu May 19 2011 - 21:18:51 ART