From: ccie preparation (ccie22@gmail.com)
Date: Sat Feb 14 2009 - 17:17:52 ARST
Folks,
I have 4 swicthes which are interconnected with each other.
I configure ether channel between them in a full mesh setup. I am not
using Papg or Lacp and have the ether channel in ON state. What I am
noticing is that some ether channels come up and some do not. I have
shut and no shut the port channel interfaces to get them up sometimes
and I am wasting a lot of time. They eventually come up but a lot of
shuts and no shuts. I have verified that all configuration is
consistent on the ports and the trunks come up before i try to build
the ether channels.
Any help would be highly appreciated.
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sun Mar 01 2009 - 09:44:11 ARST