From: lovnish.sharma@bt.com
Date: Mon Dec 22 2008 - 12:48:01 ARST
Hi,
IEWB Dynamips version 4.1 Volume 2 ---Task 1.1---Configuring routed interface on switch
This is simple query regarding configuring routed interface on a switch & giving ip address. Switch physically connects to router interface. I am performing this task on dynamips however it is not working.
As per IEWB vol2 Lab 1 please find below the physical connection & configuration:-
Router 1 (F0/0) <----> Switch 1 (F1/1)
Router 1 interface Config
Rack1R1#sh run int f0/0
Building configuration...
Current configuration : 94 bytes
!
interface FastEthernet0/0
ip address 183.1.17.1 255.255.255.0
speed 100
full-duplex
end
Rack1R1#
Switch 1 interface config
Rack1SW1#sh run int f1/1
Building configuration...
Current configuration : 109 bytes
!
interface FastEthernet1/1
description To R1 F0/0
no switchport
ip address 183.1.17.7 255.255.255.0
end
Rack1SW1#
Rack1SW1#pi 183.1.17.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 183.1.17.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Rack1SW1#
I am not able to PING these devices from each other.
Please could you advice if my configuration is correct or I need to configure some other way to achieve this task.
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:09 ARST