From: James MacDonald (j4m3sm63@yahoo.ca)
Date: Mon Dec 22 2008 - 13:16:54 ARST
I'd check the dynamips config and ensure those ports are mapped to each other ... and also that the ports are admin up on the router and switch port as well ... i know when i'm into hours of study i make some pretty odd little mistakes like forgetting to check interface status ... or more recently transposing octets in a frame map and spinning my mind into thinking dynamips doesn't work or has a bug or something ... only to go get a cup of coffee and spot my error :)
Usually things like this are errors and not a problem with the program.
------------------------------
Jim MacDonald
j4m3sm63@yahoo.ca
------------------------------
________________________________
From: "lovnish.sharma@bt.com" <lovnish.sharma@bt.com>
To: ccielab@groupstudy.com
Sent: Monday, December 22, 2008 9:48:01 AM
Subject: IEWB Dynamips vol2 v4.1 lab 1 Task 1.1-No Switchport config query
Hi,
IEWB Dynamips version 4.1 Volume 2 ---Task 1.1---Configuring routed interface on switch
This is simple query regarding configuring routed interface on a switch & giving ip address. Switch physically connects to router interface. I am performing this task on dynamips however it is not working.
As per IEWB vol2 Lab 1 please find below the physical connection & configuration:-
Router 1 (F0/0) <----> Switch 1 (F1/1)
Router 1 interface Config
Rack1R1#sh run int f0/0
Building configuration...
Current configuration : 94 bytes
!
interface FastEthernet0/0
ip address 183.1.17.1 255.255.255.0
speed 100
full-duplex
end
Rack1R1#
Switch 1 interface config
Rack1SW1#sh run int f1/1
Building configuration...
Current configuration : 109 bytes
!
interface FastEthernet1/1
description To R1 F0/0
no switchport
ip address 183.1.17.7 255.255.255.0
end
Rack1SW1#
Rack1SW1#pi 183.1.17.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 183.1.17.1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Rack1SW1#
I am not able to PING these devices from each other.
Please could you advice if my configuration is correct or I need to configure some other way to achieve this task.
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:09 ARST