From: ccie1101 (ccie1101@gmail.com)
Date: Sun Aug 26 2007 - 12:49:42 ART
I have a question that says the following :-
----------------------------------------------------------------------------------------
Configure FR connection between R3 and R5.
Do not use the frame relay map command on either R3 or R5.
Do not allow Inverse-Arp request to be sent out any DLCIs other then 315 and
513 ...
--------------------------------------------------------------------------------------------
What I did was shut the interface, did a 'clear frame inarp' and then did a
'sh frame-relay pvc | inc DLCI' and look for all the DLCI's other then 315
and 513 and typed the
following command on the serial interface ...
int s0/0
no frame-relay inverse-arp ip 301
no frame-relay inverse-arp ip 302
no frame-relay inverse-arp ip 303
no frame-relay inverse-arp ip 304
and did a 'no shut' .... Is this correct, if not, what is the right steps
to tackle this problem ? The reason being is that after I have put
in the command, I still see all these DLCIs in and is in ACTIVE state.
Rack1R3(config-if)#do sh frame pvc | inc DLCI
DLCI = 301, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0/0
DLCI = 302, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
Serial0/0/0.302
DLCI = 304, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0/0
DLCI = 305, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0/0/0
Pls enlighten,
Thank you,
ccie1101.
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:13 ART