From: ccie1101 (ccie1101@gmail.com)
Date: Sun Aug 26 2007 - 13:38:41 ART
I just want to check the sequence of steps are right ... I don't have the
commands I put in on the day I did the lab ....
Is the steps right ?
Here is what I did :-
1) Shutdown the interface 2) Disable frame-relay inverse-arp with the
command 'no frame-relay inverse-arp'. 3) Bring back the interface up with a
'no shut'. 4) Clear inarp on the intrerface with the command 'clear
frame-relay inverse-arp'. 5) Do a 'sh frame-relay pvc | inc DLCI' 6)
Disable the inverse-ARP for the unused DLCI's 7) Reenable inverse-arp for
the whole interface with the command 'frame-relay inverse-arp'.
Thank you,
ccie1101.
On 8/27/07, Bajo <bajoalex@gmail.com> wrote:
>
> Hi pls post you serial interface config from all the routers...am not
> sure if u r working on the correct interface ....
>
> On 8/26/07, ccie1101 <ccie1101@gmail.com> wrote:
> > I have a question that says the following :-
> >
> >
> ----------------------------------------------------------------------------------------
> > Configure FR connection between R3 and R5.
> > Do not use the frame relay map command on either R3 or R5.
> > Do not allow Inverse-Arp request to be sent out any DLCIs other then 315
> and
> > 513 ...
> >
> --------------------------------------------------------------------------------------------
> >
> > What I did was shut the interface, did a 'clear frame inarp' and then
> did a
> >
> > 'sh frame-relay pvc | inc DLCI' and look for all the DLCI's other then
> 315
> > and 513 and typed the
> > following command on the serial interface ...
> >
> > int s0/0
> > no frame-relay inverse-arp ip 301
> > no frame-relay inverse-arp ip 302
> > no frame-relay inverse-arp ip 303
> > no frame-relay inverse-arp ip 304
> >
> > and did a 'no shut' .... Is this correct, if not, what is the right
> steps
> > to tackle this problem ? The reason being is that after I have put
> > in the command, I still see all these DLCIs in and is in ACTIVE state.
> >
> > Rack1R3(config-if)#do sh frame pvc | inc DLCI
> > DLCI = 301, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
> Serial0/0/0
> > DLCI = 302, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
> > Serial0/0/0.302
> > DLCI = 304, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
> Serial0/0/0
> > DLCI = 305, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE =
> Serial0/0/0
> >
> >
> > Pls enlighten,
> >
> > Thank you,
> > ccie1101.
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
>
>
> --
> Kind Regards,
>
> Bajo
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:13 ART