From: Cisco Key (ciscokey@googlemail.com)
Date: Tue May 15 2007 - 09:29:42 ART
Hi Group
I do apologise if this question has been asked a million times before, but I
have been searching the archives and have still not found any definitive
answer on the use/uselessness of ARP Frame-relay,
I have found the following:
ARP Frame-relay no arp frame-relay" also to circumvent sending out ip
address to DLCI binding information no arp frame-relay that this will kill
auto install Router(config-if)no frame-relay inverse-arp Disables the
sending of Inverse ARP requests. Use this command in conjunction with no
arp frame-relay to prevent the dynamic mapping of PVCs. Router(config-if)no
arp frame-relay Disables ARP responses. Use this in conjunction with the
no frame-relay inverse-arp command.
Is this command really needed, I know this use to be used with ATM, but I do
not really see the use of this command if no frame-relay inverse-arp does
the job
Please comment
Thanks
Paul
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:21 ART