From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Tue May 15 2007 - 13:12:42 ART
The "no arp frame-relay" command does not stop the router from sending
inverse-ARP requests or replying to inverse-ARP requests. The command does
not have any effect on inverse-ARP whatsoever. If you think about it there
isn't support for ARP in Frame Relay to begin with so why would you ever
need to disable it? Frame Relay supports inverse-ARP but not ARP.
Inverse Address Resolution Protocol
http://www.internetworkexpert.com/rfc/rfc1293.txt
HTH,
Brian Dennis, CCIE4 #2210 (R&S/ISP-Dial/Security/SP)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
On 5/15/07 5:29 AM, "Cisco Key" <ciscokey@googlemail.com> wrote:
> Hi Group
>
> I do apologise if this question has been asked a million times before, but I
> have been searching the archives and have still not found any definitive
> answer on the use/uselessness of ARP Frame-relay,
>
> I have found the following:
>
> ARP Frame-relay no arp frame-relay" also to circumvent sending out ip
> address to DLCI binding information no arp frame-relay that this will kill
> auto install Router(config-if)no frame-relay inverse-arp Disables the
> sending of Inverse ARP requests. Use this command in conjunction with no
> arp frame-relay to prevent the dynamic mapping of PVCs. Router(config-if)no
> arp frame-relay Disables ARP responses. Use this in conjunction with the
> no frame-relay inverse-arp command.
>
> Is this command really needed, I know this use to be used with ATM, but I do
> not really see the use of this command if no frame-relay inverse-arp does
> the job
>
> Please comment
>
> Thanks
> Paul
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:21 ART