From: allboutcisco (frenzeus@streamyx.com)
Date: Tue Apr 25 2006 - 13:39:30 GMT-3
Hi group,
I believe if the proper order of configuration is carried out for frame relay, there won't be mappings to 0.0.0.0. The following is what i did but am still getting the 0.0.0.0 maps.
Rack1R6#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Rack1R6(config)#int s0/0
Rack1R6(config-if)#do sh run int s0/0
Building configuration...
Current configuration : 93 bytes
!
interface Serial0/0
ip address 54.1.1.6 255.255.255.0
no dce-terminal-timing-enable
end
Rack1R6(config-if)#sh
*Mar 1 04:36:28.317: %LINK-5-CHANGED: Interface Serial0/0, changed state to administratively down
Rack1R6(config-if)#enc fram
Rack1R6(config-if)#no fram inv
Rack1R6(config-if)#fram map ip 54.1.1.254 101 br
Rack1R6(config-if)#no sh
Rack1R6(config-if)#^Z
*Mar 1 04:37:16.372: %SYS-5-CONFIG_I: Configured from console by console
Rack1R6#sh fram map
Serial0/0 (up): ip 0.0.0.0 dlci 401(0x191,0x6410)
broadcast,
CISCO, status defined, inactive
Serial0/0 (up): ip 0.0.0.0 dlci 301(0x12D,0x48D0)
broadcast,
CISCO, status defined, inactive
Serial0/0 (up): ip 54.1.1.254 dlci 101(0x65,0x1850), static,
broadcast,
CISCO, status defined, inactive
Rack1R6#
*Mar 1 04:37:18.295: %LINK-3-UPDOWN: Interface Serial0/0, changed state to up
I found a thread on this posted some time back and he tried to do the static mappings after doing a "no shut". I've tried that as well, but these darn zeroes are still showing up...
Thanks in advance.
-K
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:59 GMT-3