From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Tue Apr 25 2006 - 15:31:57 GMT-3
In newer IOSs the router will automatically detect frame relay encapsulation
from the cloud if the interface is up/up. Did you look at the running config
on the interface or the show frame-relay map output before you started your
configuration? If this happens in the lab don't sweat it, just configure your
frame relay normally, save the config, reload, and move on to a different
device.
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
________________________________
From: nobody@groupstudy.com on behalf of allboutcisco
Sent: Tue 4/25/2006 11:39 AM
To: Cisco certification
Subject: Frame relay order of operation
Hi group,
I believe if the proper order of configuration is carried out for frame relay,
there won't be mappings to 0.0.0.0. The following is what i did but am still
getting the 0.0.0.0 maps.
Rack1R6#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Rack1R6(config)#int s0/0
Rack1R6(config-if)#do sh run int s0/0
Building configuration...
Current configuration : 93 bytes
!
interface Serial0/0
ip address 54.1.1.6 255.255.255.0
no dce-terminal-timing-enable
end
Rack1R6(config-if)#sh
*Mar 1 04:36:28.317: %LINK-5-CHANGED: Interface Serial0/0, changed state to
administratively down
Rack1R6(config-if)#enc fram
Rack1R6(config-if)#no fram inv
Rack1R6(config-if)#fram map ip 54.1.1.254 101 br
Rack1R6(config-if)#no sh
Rack1R6(config-if)#^Z
*Mar 1 04:37:16.372: %SYS-5-CONFIG_I: Configured from console by console
Rack1R6#sh fram map
Serial0/0 (up): ip 0.0.0.0 dlci 401(0x191,0x6410)
broadcast,
CISCO, status defined, inactive
Serial0/0 (up): ip 0.0.0.0 dlci 301(0x12D,0x48D0)
broadcast,
CISCO, status defined, inactive
Serial0/0 (up): ip 54.1.1.254 dlci 101(0x65,0x1850), static,
broadcast,
CISCO, status defined, inactive
Rack1R6#
*Mar 1 04:37:18.295: %LINK-3-UPDOWN: Interface Serial0/0, changed state to
up
I found a thread on this posted some time back and he tried to do the static
mappings after doing a "no shut". I've tried that as well, but these darn
zeroes are still showing up...
Thanks in advance.
-K
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:59 GMT-3