From: m destienne (mdestienne@yahoo.com)
Date: Wed Mar 29 2006 - 13:33:56 GMT-3
i see that you have only one virtual template defined
but listed twice. and this one is being used by both
frame interfaces.
is that a typo or should the second virtual template
be virtual-template2 and used by the second frame
interface..
this way, you would have two virtual templates in the
mlppp config instead of just one.
also, verify that the flapping messages are bogus by
checking the serial interfaces when you receive the
down messages regarding your mlppp.
--- Bill.McKenzie@bisys.com wrote:
> IE Core Lab 6:
>
> configuring PPPoFR with multilink interfaces
>
> Routers 3 and 4 can communicate no problem. Router
> 5's multilink interface
> is constantly going up and down. The configuration
> (except for interface
> number) is the same on all three routers.
>
> Here is the config on the suspect router (R5)
>
> interface Serial1/0
> no ip address
> encapsulation frame-relay
> frame-relay lmi-type cisco
> !
> interface Serial1/0.503 point-to-point
> frame-relay interface-dlci 503 ppp
> Virtual-Template1
> !
> interface Serial1/0.513 point-to-point
> frame-relay interface-dlci 513 ppp
> Virtual-Template1
> !
>
> interface Virtual-Template1
> no ip address
> ppp multilink
> ppp multilink group 1
>
>
> interface Virtual-Template1
> no ip address
> ppp multilink
> ppp multilink group 1
> end
>
> interface Multilink1
> ip address 145.1.0.5 255.255.255.0
> no cdp enable
> ppp multilink
> ppp multilink group 1
> end
>
> Has anyone experienced this before?
>
> TIA,
> Bill
>
>
>
>
>
>
>
> ============================================
> STATEMENT OF CONFIDENTIALITY
>
> The information contained in this electronic message
> and any attachments to
> this message are intended for the exclusive use of
> the addressee(s) and may
> contain confidential or privileged information. No
> representation is made
> on its accuracy or completeness of the information
> contained in this
> electronic message. Certain assumptions may have
> been made in the
> preparation of this material as of this date, and
> are subject to change
> without notice. If you are not the intended
> recipient, you are hereby
> notified that any dissemination, distribution or
> copying of this e-mail and
> any attachment(s) is strictly prohibited.
>
> Please reply to the sender and destroy all copies of
> this message and any
> attachments from your system.
>
>
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:40 GMT-3