From: Bill.McKenzie@bisys.com
Date: Wed Mar 29 2006 - 10:23:20 GMT-3
IE Core Lab 6:
configuring PPPoFR with multilink interfaces
Routers 3 and 4 can communicate no problem. Router 5's multilink interface
is constantly going up and down. The configuration (except for interface
number) is the same on all three routers.
Here is the config on the suspect router (R5)
interface Serial1/0
no ip address
encapsulation frame-relay
frame-relay lmi-type cisco
!
interface Serial1/0.503 point-to-point
frame-relay interface-dlci 503 ppp Virtual-Template1
!
interface Serial1/0.513 point-to-point
frame-relay interface-dlci 513 ppp Virtual-Template1
!
interface Virtual-Template1
no ip address
ppp multilink
ppp multilink group 1
interface Virtual-Template1
no ip address
ppp multilink
ppp multilink group 1
end
interface Multilink1
ip address 145.1.0.5 255.255.255.0
no cdp enable
ppp multilink
ppp multilink group 1
end
Has anyone experienced this before?
TIA,
Bill
============================================
STATEMENT OF CONFIDENTIALITY
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain confidential or privileged information. No representation is made
on its accuracy or completeness of the information contained in this
electronic message. Certain assumptions may have been made in the
preparation of this material as of this date, and are subject to change
without notice. If you are not the intended recipient, you are hereby
notified that any dissemination, distribution or copying of this e-mail and
any attachment(s) is strictly prohibited.
Please reply to the sender and destroy all copies of this message and any
attachments from your system.
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:40 GMT-3