From: CCIEin2006 (ciscocciein2006@gmail.com)
Date: Mon Jan 09 2006 - 17:46:51 GMT-3
Hello All,
Sometimes when configuring frame-relay subinterfaces I accidentally
configure the wrong interface type but the only way I can change it is by
removing the interface and rebooting.
Is there a way to do this without rebooting?
R5#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R5(config)#int ser0/0.5 point-to-point
R5(config)#int ser0/0.5 multipoint
% Warning: cannot change link type
R5(config-subif)#
R5(config-subif)#exit
R5(config)#no int ser0/0.5 point-to-point
Not all config may be removed and may reappear after reactivating the
sub-interface
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:48 GMT-3