From: Pallavi Srinivasa (pallavi.srinivasa@gmail.com)
Date: Tue Jan 10 2006 - 06:21:02 GMT-3
Another way is to change the encapsulation on the interface, reload the
router and then build frame relay config. This worked for me.
On 1/9/06, Jonathan Stevens <jonathanstevens.net@googlemail.com> wrote:
>
> One alternative (which will save you a lot of time) is to use a
> different subinterface number for your new interface. This will save you
> time.
>
> CCIEin2006 wrote:
>
> >Hello All,
> >
> >Sometimes when configuring frame-relay subinterfaces I accidentally
> >configure the wrong interface type but the only way I can change it is by
> >removing the interface and rebooting.
> >
> >Is there a way to do this without rebooting?
> >
> >R5#conf t
> >Enter configuration commands, one per line. End with CNTL/Z.
> >R5(config)#int ser0/0.5 point-to-point
> >R5(config)#int ser0/0.5 multipoint
> >% Warning: cannot change link type
> >R5(config-subif)#
> >R5(config-subif)#exit
> >R5(config)#no int ser0/0.5 point-to-point
> >Not all config may be removed and may reappear after reactivating the
> >sub-interface
> >
> >_______________________________________________________________________
> >Subscription information may be found at:
> >http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:48 GMT-3