From: John Matus (John.Matus@tokiom.com)
Date: Mon Jan 09 2006 - 17:46:01 GMT-3
if you are creating an etherchannel w/ 2 ports and you want to have it
negotiated via pagp.........
int range fa0/13 - 14
channel-g 1 mode desirable
channel-g protocol pagp
int po1
switch trunk encap dot1q
<switch mode trunk>
does it matter if you leave off the "switch mode trunk" under the po1
interface? i thought you needed this but i'm looking at an IE solution
guide and it does not show "switch mode trunk"......i know that if you set
it to "switchport nonegotiate" it stops DTP frame from being sent out, but
i'm not sure if the "switch mode trunk" stops pagp from operating correctly
<???>
TIA
Regards,
John D. Matus
Technical Support / PAS
Fujitsu Consulting
626-568-7716
John.Matus@tokiom.com
========================================================================================================
This e-mail is intended solely for the individual to whom it is
addressed. The information contained in this transmission contains
confidential and/or proprietary information or is otherwise privileged. If
the reader of this message is not the intended recipient, please be advised
that any dissemination, distribution or copying of this transmission is
strictly prohibited. If you have received this e-mail in error, please
notify us immediately by returning it to the sender and deleting this copy
from your system. Thank you for your cooperation.
========================================================================================================
This archive was generated by hypermail 2.1.4 : Wed Feb 01 2006 - 07:45:48 GMT-3