From: Mathew (mathew@oztralia.com)
Date: Tue May 24 2005 - 04:46:13 GMT-3
Hi Team
Does anybody know why I can not enable IPV6 OSPF on 2600 with IOS ver
12.2(15)T15?
Even after configuring "ipv6 unicast-routing" and "ipv6 enable" under the
interface, I do not see
a OSPF option.
Does anybody know why it is so?
R2(config-if)#ipv6 ?
IPv6 interface subcommands:
address Configure IPv6 address on interface
cef Cisco Express Forwarding for IPv6
enable Enable IPv6 on interface
mtu Set IPv6 Maximum Transmission Unit
nat Enable IPv6 NAT on interface
nd IPv6 interface Neighbor Discovery subcommands
redirects Enable sending of ICMP Redirect messages
rip Configure RIP routing protocol
router IPv6 Router interface commands
traffic-filter Access control list for packets
unnumbered Preferred interface for source address selection
verify Enable per packet validation
R2(config-if)#ipv6 ro
R2(config-if)#ipv6 router ?
isis IS-IS Routing for IPv6
R2(config-if)#ipv6 router
R2(config-if)#do sho ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.2(15)T15, RELEASE
SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Thu 03-Mar-05 03:28 by hqluong
Image text-base: 0x80008098, data-base: 0x81960D40
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-J1S3-M), Version 12.2(15)T15, RELEASE SOFTWARE
(fc1)
R2 uptime is 47 minutes
System returned to ROM by power-on
System image file is "flash:c2600-j1s3-mz.122-15.T15.bin"
cisco 2610 (MPC860) processor (revision 0x203) with 61440K/4096K bytes of
memory.
Processor board ID JAD05090GQQ (1222274526)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
16 terminal line(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
R2(config-if)#
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:12:00 GMT-3