From: kuldip singh (dipa.singh@gmail.com)
Date: Wed Mar 16 2005 - 16:14:59 GMT-3
Hi
I have just been doing lab2 in IE and for some reason I just can't get the
default route being sent to R6.
R2: is level-1-2 router and Router 6 is level-1 router but using sub-interface
on ethernet. If I change R6 to level-1-2 router than I can see all the
routes ok on R6. But R6 is configured as Level-1 I can't see the default.
Any suggestions:
config on R2:
interface Ethernet0/0
ip address 132.1.26.2 255.255.255.0
ip router isis
half-duplex
isis circuit-type level-1
router isis
net 49.0001.0001.0001.0002.00
summary-address 51.0.0.0 255.248.0.0
redistribute ospf 1
passive-interface Loopback0
R2: has L1 and L2 routes:
R6:
interface Ethernet0.26
encapsulation dot1Q 26
ip address 132.1.26.6 255.255.255.0
ip router isis
router isis
net 49.0001.0001.0001.0006.00
passive-interface Loopback0
is-type level-1
Routes on R6:
Rack1R6#sh ip route isis
51.0.0.0/16 is subnetted, 8 subnets
i L1 51.3.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.2.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.1.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.0.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.7.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.6.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.5.0.0 [115/10] via 54.1.2.254, ATM0.1
i L1 51.4.0.0 [115/10] via 54.1.2.254, ATM0.1
54.0.0.0/24 is subnetted, 2 subnets
i L1 54.1.4.0 [115/20] via 54.1.2.254, ATM0.1
150.1.0.0/24 is subnetted, 2 subnets
i L1 150.1.2.0 [115/10] via 132.1.26.2, Ethernet0.26
Rack1R6#
Rack1R6#sh clns neig
System Id Interface SNPA State Holdtime Type Protocol
Rack1R2 Et0.26 0030.9436.24e0 Up 26 L1 IS-IS
BB1 AT0.1 VC 6 Up 27 L1 IS-IS
Rack1R6#
Appreciate any info Thanks
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:46 GMT-3