3700 series router - ethernet switch module.

From: Paul Chen (cpjchen@starhub.net.sg)
Date: Tue Nov 18 2003 - 00:00:55 GMT-3

Hi All,

I found an CCO article that says you can configure Layer 3 interfaces on the
16 port ethernet switch module for the 3700 series router. It is on the
section configuring layer 3 interfaces.

Having tested it out, I found out that it can't be done.

Can anyone verify that ?

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_guid
e09186a008018165b.html

Router(config-if)#no switchport ?
  access Set access mode characteristics of the interface
  mode Set trunking mode of the interface
  priority Set 802.1p priorities
  trunk Set trunking characteristics of the interface
  voice Voice appliance attributes

Router(config-if)#no switchport
% Incomplete command.

Router(config-if)#no switchport ac
Router(config-if)#no switchport access
% Incomplete command.

Router(config-if)#no switchport access ?
  vlan Set VLAN when interface is in access mode

Router(config-if)#no switchport access vl
Router(config-if)#no switchport access vlan
Router(config-if)#ip add 10.1.1.2 255.0.0.0

% IP addresses may not be configured on L2 links.

Router(config-if)#

Thanks,
Paul

This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:13 GMT-3