From: MADMAN (dmadlan@qwest.com)
Date: Tue Nov 18 2003 - 11:28:04 GMT-3
You can configure a layer three interface, indirectly:
C3745(config-if)#inter fa 2/0
C3745(config-if)#switchport access vlan 100
C3745(config-if)#inter vlan 100
C3745(config-if)#ip add 100.1.1.1 255.0.0.0
Dave
Paul Chen wrote:
> Hi All,
>
> I found an CCO article that says you can configure Layer 3 interfaces on the
> 16 port ethernet switch module for the 3700 series router. It is on the
> section configuring layer 3 interfaces.
>
> Having tested it out, I found out that it can't be done.
>
> Can anyone verify that ?
>
>
> http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_guid
> e09186a008018165b.html
>
>
>
> Router(config-if)#no switchport ?
> access Set access mode characteristics of the interface
> mode Set trunking mode of the interface
> priority Set 802.1p priorities
> trunk Set trunking characteristics of the interface
> voice Voice appliance attributes
>
> Router(config-if)#no switchport
> % Incomplete command.
>
> Router(config-if)#no switchport ac
> Router(config-if)#no switchport access
> % Incomplete command.
>
> Router(config-if)#no switchport access ?
> vlan Set VLAN when interface is in access mode
>
> Router(config-if)#no switchport access vl
> Router(config-if)#no switchport access vlan
> Router(config-if)#ip add 10.1.1.2 255.0.0.0
>
> % IP addresses may not be configured on L2 links.
>
> Router(config-if)#
>
> Thanks,
> Paul
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367"Emotion should reflect reason not guide it"
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:13 GMT-3