From: Larry Letterman (lletterm@cisco.com)
Date: Tue Nov 18 2003 - 05:28:40 GMT-3
I have one in my cube, and it cant be done on the one I have.
I can only do L2 SVI's..
Larry Letterman
Cisco Systems
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Paul Chen
Sent: Monday, November 17, 2003 7:01 PM
To: ccielab@groupstudy.com
Subject: 3700 series router - ethernet switch module.
Hi All,
I found an CCO article that says you can configure Layer 3 interfaces on
the 16 port ethernet switch module for the 3700 series router. It is on
the section configuring layer 3 interfaces.
Having tested it out, I found out that it can't be done.
Can anyone verify that ?
http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_
guid
e09186a008018165b.html
Router(config-if)#no switchport ?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
priority Set 802.1p priorities
trunk Set trunking characteristics of the interface
voice Voice appliance attributes
Router(config-if)#no switchport
% Incomplete command.
Router(config-if)#no switchport ac
Router(config-if)#no switchport access
% Incomplete command.
Router(config-if)#no switchport access ?
vlan Set VLAN when interface is in access mode
Router(config-if)#no switchport access vl
Router(config-if)#no switchport access vlan Router(config-if)#ip add
10.1.1.2 255.0.0.0
% IP addresses may not be configured on L2 links.
Router(config-if)#
Thanks,
Paul
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:13 GMT-3