From: Jennifer Bellucci (jennifer_bellucci@hotmail.com)
Date: Sun Apr 27 2003 - 03:38:24 GMT-3
Hello People
r1----r2-----r3
R1 / 2 is running RIPV2. R2 / 3 is running EIGRP.
Routers only have the serials and loopback interfaces only. Very simple
network. On R2, when I try to red loopback as a connected interface, it never
appears on EIGRP network. It appears on the RIP side with no problems. The red
commands are simple:
access-list 1 permit 148.10.11.1 0.0.0.255
route-map loopback2rip permit 10
match ip add 1
router rip
red conn loopback2rip
---------------------------------
router eigrp 21
red rip metric 10000 100 255 1 1500
As you can see, its a basic setup and my fundamental knowledge has again let
me down....(don't worry I am thinking of creative ways of ending the
never-ending story).
I'd appreciate it if you could help me out, its most likely a command I am
missing or something as when the loop is put directly under RIP is jumps into
EIGRP instantly.
See u when u Get there
Jennifer B"ll{cci 3
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:08 GMT-3