From: Marc (tan@dia.janis.or.jp)
Date: Sun Apr 27 2003 - 11:48:58 GMT-3
Put a network command under rip for the loopback instead of redist connected
command.
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Jennifer Bellucci
> Sent: Sunday, April 27, 2003 3:38 PM
> To: ccielab@groupstudy.com
> Subject: RIP 2 EIGRP RED
>
>
> Hello People
>
> r1----r2-----r3
>
> R1 / 2 is running RIPV2. R2 / 3 is running EIGRP.
> Routers only have the serials and loopback interfaces only.
> Very simple
> network. On R2, when I try to red loopback as a connected
> interface, it never
> appears on EIGRP network. It appears on the RIP side with no
> problems. The red
> commands are simple:
>
> access-list 1 permit 148.10.11.1 0.0.0.255
> route-map loopback2rip permit 10
> match ip add 1
> router rip
> red conn loopback2rip
> ---------------------------------
> router eigrp 21
> red rip metric 10000 100 255 1 1500
>
> As you can see, its a basic setup and my fundamental
> knowledge has again let
> me down....(don't worry I am thinking of creative ways of ending the
> never-ending story).
>
> I'd appreciate it if you could help me out, its most likely a
> command I am
> missing or something as when the loop is put directly under
> RIP is jumps into
> EIGRP instantly.
>
> See u when u Get there
> Jennifer B"ll{cci 3
>
> Jennifer_bellucci@hotmail.com
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:08 GMT-3