From: Blanco Lam (b@gclamb.com)
Date: Sun Apr 27 2003 - 07:16:14 GMT-3
Jennifer,
I think you're missing "no auto-summary" under your RIP process on r1.
You probably won't need the "no auto-summary" on r2, but I'll add it anyway.
Regards,
Blanco
---- Original message ----
>Date: Sun, 27 Apr 2003 07:38:24 +0100
>From: "Jennifer Bellucci" <jennifer_bellucci@hotmail.com>
>Subject: RIP 2 EIGRP RED
>To: <ccielab@groupstudy.com>
>
>Hello People
>
>r1----r2-----r3
>
>R1 / 2 is running RIPV2. R2 / 3 is running EIGRP.
>Routers only have the serials and loopback interfaces only. Very simple
>network. On R2, when I try to red loopback as a connected interface, it never
>appears on EIGRP network. It appears on the RIP side with no problems. The red
>commands are simple:
>
>access-list 1 permit 148.10.11.1 0.0.0.255
>route-map loopback2rip permit 10
>match ip add 1
>router rip
>red conn loopback2rip
>---------------------------------
>router eigrp 21
>red rip metric 10000 100 255 1 1500
>
>As you can see, its a basic setup and my fundamental knowledge has again let
>me down....(don't worry I am thinking of creative ways of ending the
>never-ending story).
>
>I'd appreciate it if you could help me out, its most likely a command I am
>missing or something as when the loop is put directly under RIP is jumps into
>EIGRP instantly.
>
>See u when u Get there
>Jennifer B"ll{cci 3
>
>Jennifer_bellucci@hotmail.com
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:08 GMT-3