From: Corey.Reynolds@datacraft.co.nz
Date: Sun Dec 01 2002 - 05:33:13 GMT-3
Hi,
I have seen a weird problem on a 2500 where it incorrectly reported a 4M and an 8M as being 16M total. This caused it to report 16M but refuse to load any image greater than 12M.
Checking the flash individually showed one of them was actually a 4M simm.
> I am having a problem upgrading my IOS. I have 16M Flash and
> 16M Memory. Here is the output of show ver:
>
> cisco 2522 (68030) processor (revision M) with 14336K/2048K
> bytes of memory.
> Processor board ID 02936846, with hardware revision 00000001
> Bridging software.
> X.25 software, Version 3.0.0.
> Basic Rate ISDN software, Version 1.1.
> 1 Ethernet/IEEE 802.3 interface(s)
> 2 Serial network interface(s)
> 8 Low-speed serial(sync/async) network interface(s)
> 1 ISDN Basic Rate interface(s)
> 32K bytes of non-volatile configuration memory.
> 16384K bytes of processor board System flash (Read ONLY)
>
> When I try to do a copy tftp flash, I get the following message:
> %Error: Image size exceeds free space
>
> The image I am trying to load is only 14,152KB in size. It
> seems that I do have enough space for this image, could
> anyone help to explain this? Thanks in advance...
>
#####################################################################################
This e-mail message has been scanned for Viruses and Content and cleared
by MailMarshal
For more information please visit www.marshalsoftware.com
#####################################################################################
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:37 GMT-3