From: Ron (id353@singnet.com.sg)
Date: Sun Dec 01 2002 - 06:20:06 GMT-3
So the best method to deploy will still be to define all neighbors on the hub and leave the spokes as it is with "ip ospf pri 0".
Is that correct.
TIA.
Ron
From Brian Dennis <brian@5g.net> on 30 Nov 2002:
> Yes, if you set the OSPF priority under the interface you can't also use
> the neighbor statement for a neighbor on that same interface.
>
> Brian Dennis, CCIE #2210 (R&S/ISP Dial/Security)
>
> -----Original Message-----
> From: Ron [mailto:id353@singnet.com.sg]
> Sent: Saturday, November 30, 2002 11:50 PM
> To: Brian Dennis; surenv@hpssk211.sgp.hp.com; ccielab@groupstudy.com
> Subject: RE: Can't Add Nei Statement
>
> Hi Dennis,
>
> I had also experienced this problem before. Will the addition of the "ip
> ospf pri 0" under the interface denies the creation the neighbor peer ?
>
> I was using both the ip ospf pri and ip ospf hello command to convert
> the link to an NBMA. The lab I was doing would not allow the use of the
> network command.
>
> TIA.
>
> Ron
>
> >From Brian Dennis <brian@5g.net> on 30 Nov 2002:
>
> > Suren,
> > Are you also trying to use the "ip ospf priority" command under the
> > interface?
> >
> > Brian Dennis, CCIE #2210 (R&S/ISP Dial/Security)
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
> Of
> > Surendran
> > Sent: Saturday, November 30, 2002 9:16 PM
> > To: Ccielab
> > Subject: Can't Add Nei Statement
> >
> > Hi Guys,
> > I am unable to add neighbor statement when I am configuring OSPF
> > Non-broadcast network. Is there something wrong with the IOS?
> >
> > Suren
This archive was generated by hypermail 2.1.4 : Fri Jan 17 2003 - 17:21:37 GMT-3