Re: Custom Queuing Scenario

From: Richard Gallagher (rgallagh@xxxxxxxxx)
Date: Tue May 08 2001 - 07:53:15 GMT-3

• Next message: Andrew Lennon: "RE: How to inject a default route into ISIS level-1?"
• Previous message: Dhana: "Re: @&session target" command not working"
• Maybe in reply to: Tariq Sharif: "Custom Queuing Scenario"
• Next in thread: Tariq Sharif: "RE: Custom Queuing Scenario"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Tariq,

- Default bandwidth is 1500 bytes

So the follow applies:

- Queue 1 has 3000 bytes - 50%
- Queue 2 has 1500 bytes (default) - 25%
- Queue 2 uses access list 900 to clasify traffic - IPX/NCP
- Queue 4 default has 1500 (defualt)- 25%

Rich
CCIE #7211

On May 8, 11:40am, Tariq Sharif chatted about:
> Subject:Custom Queuing Scenario
> I'm looking at Caslow 1st edi page 735 Custom Queuing Scenario. I see how
> 50% bandwidth is allocated to DLSw+ but I do not follow how the example
> queue will allocate 25% bandwidth to IPX/NCP. Can someone pls shed some
> light on this. Will this example apply to any serial link (e.g. Frame) with
> any bandwidth circuit?
>
>
> Many thanks & regards.
>
> Tariq Sharif
>
> [GroupStudy.com removed an attachment of type application/ms-tnef which had a
name of winmail.dat]
> **Please read:http://www.groupstudy.com/list/posting.html
>-- End of waffle from Tariq Sharif
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Andrew Lennon: "RE: How to inject a default route into ISIS level-1?"
• Previous message: Dhana: "Re: @&session target" command not working"
• Maybe in reply to: Tariq Sharif: "Custom Queuing Scenario"
• Next in thread: Tariq Sharif: "RE: Custom Queuing Scenario"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:30:36 GMT-3